Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

CREO 3.0 - Datum flag location?

Status
Not open for further replies.

XaeroR35

Mechanical
Jun 3, 2010
18
How do I get Datum flag B to be above the tolerance block? I need to show B above the perpendicularity.

URL]
 
Replies continue below

Recommended for you

Why? I don't recall that as a standards requirement.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor