Creo-Sub Assembly BOM

[WGarrity]

Hello,

I have a drawing of an assembly, which contains a sub assembly, but I would like the BOM for the whole assembly to include the components of the sub assembly. I haven't been able to find a way to do this yet. I have the BOM started for the parts that are not n the sub assembly but can't figure out how to add those last couple parts.


Hopefully there's an easy way to do this without rebuild the whole assembly.

Thanks!

 

[robertib]

If the BOM is a table on the drawing, then you can set it to be recursive - this will not show the sub-assembly, but will show all of the parts in it.

You haven't said which version of Pro/E you are using, but if you search the help files for repeat region, you can get how to access the menu options - one is for Flat/Recursive/Recursive no repeats.