Crimp Confusion Bigtime - Part 2

[krus1972]

I was asked to duplicate the crimping exactly as shown in this picture:

http://www.product.info/images/crimppicture.jpg

They sent me a picture of this tool which is what did the crimping in the previous picture:

http://www.product.info/images/crimptool.jpg

This tool no longer exists. Can anyone tell me what this tool is and where I can get one?


Details on the crimping and material:

1. Material is aluminum
2. Diameter is .250"
3. ID is .245"
4. Crimp needs to be approx .200" , so .025" per side
5. Disregard the rubber hose on the right. The material under the hose is the same aluminum as shown on the left.

What kind of tool is that and where Can I get one?

Any help would be well appreciated.

 

[hydtools]

Like this one?

http://www.discounthydraulichose.com/product_p/660t.htm

Ted

 

[krus1972]

Not sure, I would have to actually see it and try it.

Do you have any other links to other ones that appear to do the same?

 

[krus1972]

That one doesn't have a die small enough. Wonder if they make them smaller. I may have to call them.