Cross-section creation aborted

[AndTheWinnerIs]

I am trying to make a section view of an assembly. I have 2 sections views which were created in the model. Section A is going thru a certain feature and Section B is going thru the Right Datum plane which is the center of the assembly. I go to the drawing and try entering in Section A and it just looks like a standard side view and I get a message saying:

Cross-section creation in view "right_12", on sheet 1, aborted.

What am I doing wrong?

 

[dgallup]

Sounds like the section plane is coincident to tangent to a model surface. Pro/E frequently has trouble creating drawing sections in these cases. Try moving the section forward or backward slightly (make an new plane offset from the original so you can vary it).

----------------------------------------

The Help for this program was created in Windows Help format, which depends on a feature that isn't included in this version of Windows.

 

[AndTheWinnerIs]

dgallup - I tried that and it worked! I offset my section plane by 0.1mm and it worked fine. Thanks for your help!