Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Curved dimensions in CATDrawing 1

Status
Not open for further replies.

Macm_020171

Aerospace
Oct 12, 2022
24
US
Hello,

How can I do a curved dimension in a CATDrawing. This is used in composite design, when a ply EOP dimension is required on a curved surface. Normally the value of the dimension has a curve hat to specify it's not a linear dimension.
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top