CUT CONDITIONS FOR CORIAN

[QSF]

HAS ANYONE CUT 1/2 OR 3/4" CORIAN? IF SO, I WOULD REALLY APPRECIATE IF YOU COULD SHARE CUT CONDITIONS. I CUT 1/2" FREQUENTLY, BUT CAN ONLY ACHIEVE 10 IPM; ANY FASTER AND THE EDGE TAPERS IN TOO MUCH AT THE BOTTOM OF IT. ANY ADVICE GIVEN IS GREATLY APPRECIATED.

I HAVE A MAZAK STX SUPER TURBO 1.5K. PRESENTLY I USE 800 WATTS WITH AIR.

THANKS

Gary L. Ellis Jr.
Quality Steel Fabrication
Sidney, OH
gellis@woh.rr.com

 

[jsummerfield]

Carbide blades. I have fabrication details at home but will not be there for a couple of weeks.

John

 

[QSF]

John,

thanks for the input...the only problem is that we have to hold the tolerances within .003" for numbers between 100-500 pcs. per lot.

thanks anyway!!!

Gary L. Ellis Jr.
Quality Steel Fabrication
Sidney, OH
gellis@woh.rr.com