Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cutting 45 degree 10" Sch. 40 Buttweld Elbow into 22.5 degree 10" Elbow

Status
Not open for further replies.
AlbertaMecchie

AlbertaMecchie

Mechanical
Feb 17, 2021
19
I am having a very hard time finding a 22.5 degree 10" Sch. 40 elbow.

Is there anything in the ASME codes advising against cutting a 45 degree elbow down into a 22.5 degree elbow and prepping the cut end for buttwelds.

And this is for use on a slurry line, so is not technically pressure pipe.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

MJN2
  • Locked
  • Question
Elbow Stress Analysis
Replies
4
Views
577
MJN2
MJN2
Singhnishesh
  • Locked
  • Question
Weld-o-let on elbow
Replies
10
Views
812
racookpe1978
racookpe1978
FPPE
  • Locked
  • Question
ASME B31.3 - 1/2" elbow obtained from bended tube in ASME SB-165 N04400
Replies
4
Views
339
david339933
david339933
Piper Mike
  • Locked
  • Question
24" Pipe Attached Directly to 10" Fired Heater Outlet Nozzle
Replies
4
Views
276
Piper Mike
Piper Mike
thermmech
  • Locked
  • Question
Steam tracing effectiveness on 40" acid gas line
Replies
7
Views
416
Dhurjati Sen
Dhurjati Sen

Part and Inventory Search

Sponsor

Back
Top Bottom