Cutting parameters for lc1212 2 1.5 kw

[Skinnedrabbit]

Hello ,
I'm new to laser cutting and have a small job to cut in 6mm gr 304 St/St the machine has no cutting conditions for 4-5-6mm St on oxygen cut . Could somebody help with some parameters please as I'm struggling a little . Have managed today to input a new cut condition for 6mm but seem to get a lot of dross on the bottom of the cut . I'm using 1500watts 50duty 45 freq 1.5 mm gap and focal set at 0.0 . Any help would be greatly appreciated . Thanks in advance

 

[Km3l3on]

Hi... I uploaded you the cutting know how from amada. What you are interested is at page 13, but if you are new to laser cutting, i recomend reading from the begining.
Hope it helps

 

[Skinnedrabbit]

Thanks will have a good read