Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

DC Volt Centrifugal Fans

Status
Not open for further replies.

falcon1654

Mechanical
Sep 29, 2006
4
CA
I am searching for a centrifugal fan between 600 to 700 cfm with a static of about 2 to 3 inwg. The big problem is that the motor has to be between 24 to 32 volts DC. I have one at 100 pounds but the requirements state 50 to 60 pounds. If anyone has information on this please advise.


Best Regards

Falcon1654
 
Replies continue below

Recommended for you

Sounds like a custom-built fan/motor, not off-the-shelf. For that high of a pressure vs. relatively low cfm, it sounds like a boiler combustion air blower (narrow impeller, high rpm). Check with a boiler blower manufacturer for the fan. They can tell you the fan rpm & bhp req'd. Then check with a motor manufacturer to see if they have such a motor. If not ask the price to build one. Good luck and please report back on results.

 
Thanks for the advice I will try what you have suggested.


Regards

Falcon1654
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top