Ramon Palmera
Mechanical
Ladies and gentlemen,
In my company, technicians like me use the command Hole dimension table in a daily basis, in drawings of base boards on which we design and build structures.
However, the default settings in that window, Axis System and Table Parameters, are not set according to our standards.
Default settings
Custom settings
Each time we create a Hole dimension table, we must change those settings, making sure not to miss any of them.
Indeed, there will be parameters which might change each time, such as the Axis system, the table split, or even the Title.
Would anyone know how to change those settings, in order to save time and prevent mistakes?
My thanks in advance,
Ramón
In my company, technicians like me use the command Hole dimension table in a daily basis, in drawings of base boards on which we design and build structures.
However, the default settings in that window, Axis System and Table Parameters, are not set according to our standards.
Default settings
Custom settings
Each time we create a Hole dimension table, we must change those settings, making sure not to miss any of them.
Indeed, there will be parameters which might change each time, such as the Axis system, the table split, or even the Title.
Would anyone know how to change those settings, in order to save time and prevent mistakes?
My thanks in advance,
Ramón