Default lights scheme

[guimba]

Hello, I was wondering what the default lights are for SW. If I pull up a new part document and look at the lights manager does it show me the default configuration? Like where the directional lights are and their properties. Is there a default button whereby I can get all the lights back to that if I mess around with them? Thanks!

Mechanical Engineer
Field Forensics, Inc.

Engineering isn't about perfect solutions; it's about doing the best you can with limited resources. - Randy Pausch

 

[Eltron]

It depends on what version of SW you're on. The default lighting is controlled by the scene that you have attached to your template. You'll only mess it up for that part unless you save it as a template. You can always get back to where you were by selecting the scene again.

Dan

http://www.eltronresearch.com

Dan's Blog