default profile callout

[DesignBiz]

For drawings that might have a default profile callout, how is the specification in section 6.5.1 para. (a) reconciled?

(a) "An appropriate view or section is drawn showing the desired basic profile."

I take it that this is in reference to the 1st sentence of the 1st para. in 6.5.1;

"The profile tolerance specifies a uniform boundary along the true profile within which the elements of the surface must lie."

DesignBiz

 

[fcsuper]

It's been a long time since there's been a major lawsuit regarding drawings. Once the lawsuits start up again (and I can imagine that time is not far off), the importance of checkers and accurate/correct drawings will pick up. It was a series of lawsuits that lead to the creation of Y14.45 and much of its content.

Matt Lorono
CAD Engineer/ECN Analyst
Silicon Valley, CA
Lorono's SolidWorks Resources
Co-moderator of Solidworks Yahoo! Group
and Mechnical.Engineering Yahoo! Group