Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations Toost on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Deform 3D simulation

Status
Not open for further replies.

Eddus

Mechanical
Jan 11, 2019
2
error_are3ss.png


I am trying to simulate a drilling process using deform. The simulation does not run after beginning and ends at 0s (Everything's fine until database creation). I have tried out various simple examples from tutorials but everything ends up like this.
 
Replies continue below

Recommended for you

I've tried that there's no reply. But the simulation runs well for 2d.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor