Sometimes when I use the "Delete Face" command and I don't have the correct faces selected and the error window appears saying "the face(s) cannot be patched due to geometry conditions"... and I go to cancel the command.... that error window stays on the screen.... even if I close the part... the error message window even stays there if I just have the SWs start screen showing.... then I have to quit and restart SW. Anyone have this issue.... any fixes? Thanks. Using 2011 sp 4... but this also happened when using 2010.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!