Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Department conditions for Mugrip 3 rapier loom

Status
Not open for further replies.
sac79

sac79

Mechanical
Oct 26, 2009
5
What are the Department conditions(i.e Temperature & RH%) required to run polyester warp on Muller Mugrip 3 rapier looms? The Ends per cm is about 60 and pick rate is about 30 to 50 per cm. Thanks in advance..
 
Replies continue below

Recommended for you

Sort by date Sort by votes
The manufacturer is your best source for this information.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

BZLAM21
  • Locked
  • Question
Monsoon weather conditions for HVAC
Replies
5
Views
129
MedicineEng
MedicineEng
Wayne _ Lunar
  • Question
PICV for HVAC system
Replies
13
Views
707
LaciHudson
LaciHudson
H
  • Question
How to caculate heat gain for a lift ?
Replies
7
Views
2K
goutam_freelance
goutam_freelance
M
  • Question
Winter humidity set-points for HVAC modelling package
Replies
1
Views
1K
HVAC-Novice
HVAC-Novice
M_J_S
  • Question
Derivation for 4005 in velocity pressure equation imperial units
Replies
0
Views
928
M_J_S
M_J_S

Part and Inventory Search

Sponsor

Back
Top Bottom