Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

dependent parameters

Thread starter aliex
Start date Jun 7, 2020

Status: Not open for further replies.

Jun 7, 2020

aliex

Materials

I have three geometric parameters.

a, b and c.

i want to know where and how can i make parameter b dependent on c?

for example that c must always be greater than b, if b[5...10] und c[4...20]

a matrix was created by DesignXmodler.

but errors were shown.
is there an IF statement that can be used there?

can I program this somewhere in ANSYS? through APDL or Python?

thanks a lot