Depth symbol

[bootnreboot]

does anyone know where the real definition of the ANSI depth symbol is?
if i use the depth symbol ( the one that has a straight horizontal bar with an arrow pointing down at its midpoint ) where is this depth measured if is defining a drilled hole?
My view would show a hole with a drill point in the bottom of it. The callout could be .375 DIA X (depth symbol) 1.25
so it would be read as .375 diameter by a depth of 1.25.
where is the 1.25 measured? to the very point of the drill point shown or would it be interpretted as the depth of the .375 diameter and the drill point is not considered?
where is this defined? i do not see anything in the ANSI Y14.5 to define this.

 

[KENAT]

ASME Y14.5M-1994 1.8.9 Round Holes & figure 1-34.

Posting guidelines faq731-376

http://eng-tips.com/market.cfm?

(probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484​

 

[bootnreboot]

thank you! all i could find was the 3.3.14 and fig 3-14 but it was not defined where the depth was measured.

 

[mrainey]

In my experience, the full-diameter depth is what's being called for 99% of the time. Given that the included angle of the drill point can vary (usually either 118 or 135 degrees), it can get dicy if the material left under the drill point is thin.

Software For Metalworking

http://closetolerancesoftware.com

 

[drawoh]

bootnreboot,

ASME Y14.5M-1994 (fig 1-34) and ASME Y14.5-2009 (fig 1-36) both clearly show that specified diameter extends to the specified depth. The drill taper extends below that.

JHG