21Pom
Mechanical
- May 1, 2010
- 131
Hi All,
I've used Inventor since 2010 version and created lots of Frame layouts in the Design area and never noticed this problem until now.
I create an assembly and use the 'Insert Frame' to place mainly flat bar. Sometimes I need to alter part of my design and save assemblies as R1, R2 etc. What has just shown up is that the 'Frame #" does not alter and if I change any part of it, it also changes every prior revision to reflect the current changes. I tried to save the frame under a different name but it won't let me. Any ideas as to how one should go about this.
Best Rgds,
Dave R.
I've used Inventor since 2010 version and created lots of Frame layouts in the Design area and never noticed this problem until now.
I create an assembly and use the 'Insert Frame' to place mainly flat bar. Sometimes I need to alter part of my design and save assemblies as R1, R2 etc. What has just shown up is that the 'Frame #" does not alter and if I change any part of it, it also changes every prior revision to reflect the current changes. I tried to save the frame under a different name but it won't let me. Any ideas as to how one should go about this.
Best Rgds,
Dave R.