Design Table ? ... maybe

[Nella95]

If I've got a field in my FILE_PROPERTIES_CUSTOM tab - that I want extracted in tabular format to a drawing - is the best way to extract that data, with a Design Table? Or is there another better way? I've done searches with no luck, but perhaps I'm not searching for the correct terminology.

 

[ShaggyPE]

You can insert a "general table" into your drawing. You can set the column to display your custom property. No need for a design table. This may only work with the BOM table... give it a try.

-Dustin
Professional Engineer
Pretty good with SolidWorks