Detail view of the underside of a plate

[GeorgeEllwood]

Hello, I'm drawing a plate and most of the features are on the top surface. However there are some counter bored slots on the underside that I need to dimension. Is there a way I can create a detail view of these from the top view?

 

[prohammy]

Personally, I would create a section view to show these

Kevin

“It is a mathematical fact that fifty percent of all doctors graduate in the bottom half of their class." ~Author Unknown

"If two wrongs don't make a right, try three." ~Author Unknown

 

[proetools]

can you post a picture?

Bart Brejcha Chicago
DESIGN-ENGINE|EDUCATION

http://www.proetools.com

surfacing and Pro/CABLE training