Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

detailed threads using swept bodies

Status
Not open for further replies.

tola2000

New member
Joined
Apr 22, 2003
Messages
1
Location
US
Hi,

I want to create a detailed thread, different from the threads given in UG. My idea was to use swept bodies. I drawed a sketch which represents the thread geometry.
And I wanted to guide the sketch along a helix to create a solid, which can be substracted from a cylinder.

There are two problems.
1.)
Depending on the swept options the section (the sketch) rotates around the guide line(s). [substraction is possible]
2.)
With three guide lines it is possible to create a thread, as I wanted. But in this case, it can't be substracted from the solid (the screw).

Does anybody had a solution for that?
Any help or hint is greatly appreciated.

tola2000
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top