I would like to do a manual calculation for supports in a piping system and want to use the method outlined in the Piping Handbook. I need the position of the centroids for elbows, tees, flanges etc... for standard ANSI fittings. Does anyone know where i can find this information?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Determination of Centroids for ANSI Fittings
- Thread starter Hutamaki
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question