Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Determination of Centroids for ANSI Fittings

Thread starter Hutamaki
Start date Jul 31, 2005

Status: Not open for further replies.

Jul 31, 2005

Hutamaki

Materials

I would like to do a manual calculation for supports in a piping system and want to use the method outlined in the Piping Handbook. I need the position of the centroids for elbows, tees, flanges etc... for standard ANSI fittings. Does anyone know where i can find this information?