Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dimensional Tolerances

Thread starter KentCaudill
Start date Sep 2, 2003

Status: Not open for further replies.

Sep 2, 2003

KentCaudill

Industrial

Where can I find a definitive interpretation and examples of the allowable tolerances for the diameter of a large vessel when strapping the circumference? The minimum and maximum allowable are stated in UG-80 but I couldn't spot a discussion pertaining top the circumference as it relates to the design diameter.

Thanks for your help, Kent.