Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dimensional tolerancess for fired heaters...

Status
Not open for further replies.
emrekop

emrekop

Industrial
Dec 10, 2006
11
Hii everyone...where can I find the dimensional tolerancess for fired heater systems...? thanks...
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Some tolerances are covered in API-560, Fired Heaters for General Refinery Service.

I'm not sure if it covers your specific needs.

NozzleTwister
Houston, Texas
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

DekDee
  • Locked
  • Question
Design code of coils in Fired Heaters 3
Replies
11
Views
401
david339933
david339933
FAHADRANA
  • Question
WQT for Combination of Welders as per ASME Sec IX
Replies
1
Views
2K
weldstan
weldstan
teokal
  • Question
Saddle calculations for ASME VIII Div.2 Pressure Vessel - paragraph 4.15
Replies
0
Views
369
teokal
teokal
milosd
  • Question
ASME SB-564 Maximum section thickness for N06625
Replies
1
Views
1K
EdStainless
EdStainless
M
  • Question
SCL Placement for Fillet Welds in ASME VIII Div. 2 DBA
Replies
10
Views
2K
Mecat24
M

Part and Inventory Search

Sponsor

Back
Top Bottom