Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

dimensioning a part that is at an angle

Status
Not open for further replies.

Fonzee78

Mechanical
May 24, 2011
35
Hi all,

I am trying to get ST2 to add a dimension relative to a part, but it keeps going horizontal or vertical. Any ideas on how this could be done? I attached a sketch up of what I am trying to do and what how the dimension currently sits.

Thanks!

Joel
 
Replies continue below

Recommended for you

Got it! use the "distance between" dimension, select the first point, then select "By 2 Points" in the option box.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor