Jun 6, 2011 #1 Fonzee78 Mechanical May 24, 2011 35 0 0 US Hi all, I am trying to get ST2 to add a dimension relative to a part, but it keeps going horizontal or vertical. Any ideas on how this could be done? I attached a sketch up of what I am trying to do and what how the dimension currently sits. Thanks! Joel
Hi all, I am trying to get ST2 to add a dimension relative to a part, but it keeps going horizontal or vertical. Any ideas on how this could be done? I attached a sketch up of what I am trying to do and what how the dimension currently sits. Thanks! Joel
Jun 6, 2011 Thread starter #2 Fonzee78 Mechanical May 24, 2011 35 0 0 US Got it! use the "distance between" dimension, select the first point, then select "By 2 Points" in the option box. Upvote 0 Downvote
Got it! use the "distance between" dimension, select the first point, then select "By 2 Points" in the option box.