Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations Danlap on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dimensioning and Symbology questions on 2009 GDTP senior exam

DM888

Mechanical
Feb 4, 2025
8
For those who have taken the exam, I'd like to know if there were questions about the spec numbers for standards cited in Y14.5. I've seen some on some practice exams.

Thanks,
Dan
 
Replies continue below

Recommended for you

I took the 1994 exam a while ago, but I don't recall questions about specs/standards cited in Y14.5. Have you checked in the body of knowledge appended in Y14.5.2-2017?
 

Part and Inventory Search

Sponsor