dimensioning in sketch

[danlamb]

Is there a quick way of when using rapid dimension in sketch to change from linear measurement to an angle measurement.

Thank you

Regards Daniel Lamb.

 

[JohnRBaker]

If you're in the 'Inferred' mode if you select non-parallel references it should automatically switch to Angular and if you pick parallel references it should switch to Linear. That's the fastest way to change the Method. Otherwise you have to explicitly change the Method in the dialog.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.