Dimensions - Failure to Open Data Files

[cadrebel]

when dimensioning I am getting a "failure to open data files"
I have rebooted, replaced component, made a completely new model and drawing.
This is an issue that has just come up. I have not had the issue in the past.
any ideas?
thanks

 

[matnas]

Hello

Are you using NX7.5.4 or NX7.5.5 and NX75Custom from GTAC support forum?

Bellow is some information about it.

NX7.5.4 added new folders and files to the UGII\drafting_standards folder. I've included these in the latest update of NX75custom (attached). You may experience drafting errors if your NX75custom\CustomerDefaults\drafting_standars folder does not contain the following folders:

ansi
din
eskd
gb
iso
jis

You can also copy these files from the UGII\drafting_standars folder.

Regards

MN


NX5, NX6, NX7.5 and NX8
I-deas 12, NX I-deas6.1m1
Solid Works 2009