Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

DimExpert for Tol Analysis

Thread starter SBaugh
Start date Feb 22, 2017

Status: Not open for further replies.

Feb 22, 2017

SBaugh

Mechanical

Anyone have any luck understanding the SW help on creating a Tolerance analysis using the DimExpert? I am have been reading into this, this morning... it just seems like A LOT of work for something that I could easily just grab all the dimensions that are already in the model and figure my Tolerance using Excel. Thought I would give SW a try in this department, but it seems thrown together. Any advice?

Any help making sense of DimExpert is appreciated. The help hasn't been all that much of any help.

Thanks,

Scott Baugh, CSWP [pc2]