Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

DIN rail regulators

Status
Not open for further replies.

radioengr

Electrical
Jul 24, 2006
8
US
Does anyone know of a DIN rail mounted regulator that can accept 12V and supply 7.5V at 1A? Linear or switching it does not matter (except cooling might be a problem if linear)
 
Replies continue below

Recommended for you

Is 12 V all you have? Rail mounted PSUs for 230 or 110 V AC are common. But going from 12 to 7.5 V DC is usually done using a heat sink and a three-leg regulator. You may need a 5 V device and a voltage divider to get 7.5 V.

Gunnar Englund
--------------------------------------
100 % recycled posting: Electrons, ideas, finger-tips have been used over and over again...
 
At 1A? I'd go with switching...

Dan - Owner
Footwell%20Animation%20Tiny.gif
 
Thanks for the suggestions- my Phoenix rep came up with a great switcher solution but it's $400 list.....the EMG 75-NZG/G 5/2 will work since it has adjustable output..
 
Do your search for "DC to DC Converter" or "DC to DC Power Supply". Regulator is not a common term for them.

7.5V is not going to be common. Look for one with an adjustable output voltage that will cover that within it's range. Those in dpc's link should fit the bill however, if you get the 8V unit and adjust the output.

 
I'm sure Acopian could build you a 7.5 V output version of the 8V model. You can also use external resistors to trim the voltage.

 
Yes, that's what I meant. It has that capability built-in, no need for a special.
 
Looks like the Acopian wins, that will be my recommendation, thanks to all.
 
I gotta wonder what device wouldn't operate safely with a
regulated 0.5v overvoltage.

Sounds like a device that has a 5volt regulator of its own inside..
 
Put a diode in series with the 8V supply. Output will be somewhere between 7.3 and 7.6 depending on just how close to rating the diode junction is operating.


----------------------------------
image.php
Sometimes I only open my mouth to swap feet...
 
It's not easy being a genius...


----------------------------------
image.php
Sometimes I only open my mouth to swap feet...
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top