DIN STANDARDS

[Rich01]

Anybody can tell me if there is a DIN standard for hot rolled steel bar products (round or square) that exists beside DIN-1014-1 and DIN-1014-2?

the tolerances I'm looking for in these products is a plus or minus 0.25mm on side lenght deviation.

Thanks.

 

[sutan]

Is the product for commercial using or only the standard that you want to know for knowledge ?

 

[Rich01]

For personnal knowlecge and for products that could be produced with those tolerances. I'm working for an NDT inspection company. I do the mechanical aspect of the systemes we manufacture. We are presently doing some work for rolling mills of pretty much all kinds and want to know the standards applied to them. Any help will be appreciated

 

[sutan]

You can try to search

http://www.en.din.de

and next if I have information about it, I will contact you.
Sutan

 

[tes]

I'm looking for these DIN Standards as follows: 2559, 2527, and 28117. They will be used for pipe accessories, flanges.
Would need to find out ASAP. Thanking you & Waiting in anticipation

 

[Jlee]

Look here for info and cross references on standards.

http://metals.about.com/cs/standardsorgs/index.htm

JLee

 

The best place to find out if one DIN exists is to go to their site in

http://www.en.din.de

Best Regards