Disappearing Threads

[Heckdogg]

I have a few parts that the threads do not appear (in the side views of the holes), but the hole itself is there. The tapped holes were created using the hole wizard, and the drawing views are slightly rotated. When the drawing views are vertical/horizontal, the threads appear. Anyone else experience this? I am running SW2005 SP0.1.

Thanks

 

[CorBlimeyLimey]

That is to be expected as the cosmetic thread is a 2D representation of a thread. If the views are "slightly rotated" the cosmetic thread would have to be in 3D in order to be seen.

& all the best.