Generally when a pipeline is protected by impressed current CP system it is required to disconnect the rectifier before starting any welding on the pipeline. Do we need to disconnect a Mag anode system as well. i believe the voltage and current involved is very low in sacrificial CP system and should not be an issue even if we dont disconnect and do welding on the pipeline. is this right?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Disconnecting Cathodic Protection System
- Thread starter mat211743
- Start date
Similar threads
- Question
- Question
- Locked
- Question
- Locked
- Question