Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Display Properties Trouple

Thread starter ben82
Start date Dec 4, 2009

Status: Not open for further replies.

Dec 4, 2009

ben82

Electrical

I'm using ANSYS to generate flux density plots of brushless pm motors using the plnsol function. Two days ago the plots showed the flux density contained in the wireframe structure (see attached, left side). Now, the structure is gone and the flux densities are smeared over the area contained in the motor (see attached, right side). How do I get the wire frame of the structure back?

Thanks!
Ben