PrintScaffold
Mechanical
Greetings all!
I know this is an old question, but I didn’t find any solid answer so far.
If I have a part family and want to put data from it in the table on a drawing, I have no problem if drawing is located in the same part as the model. But if it is a non-master drawing, I there is a problem: NX won’t allow access to the part family spreadsheet of the component.
Is there a way around?
I know this is an old question, but I didn’t find any solid answer so far.
If I have a part family and want to put data from it in the table on a drawing, I have no problem if drawing is located in the same part as the model. But if it is a non-master drawing, I there is a problem: NX won’t allow access to the part family spreadsheet of the component.
Is there a way around?