Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Does anyone here interface with Tubecad?

Status
Not open for further replies.
FXjohn

FXjohn

Automotive
Mar 17, 2007
82
So far the best translation simply gives me a large 2D sheet with no independent views or much 3D. Just wondering if anyone is familiar with the program or would have any suggestions?
 
Status
Not open for further replies.

Similar threads

K
  • Question
Sew: tool does not share a common boundary
Replies
3
Views
994
cowski
cowski
MANox
  • Question
Hole with fit
Replies
0
Views
1K
MANox
MANox
Franklin M.
  • Locked
  • Question
Anyone using MULTI_AXIS_ROUGHING
Replies
3
Views
143
Rob_N
Rob_N
BCE75
  • Question
Does NX have a way to display layout guides in addition to the grid on a drawing sheet?
Replies
2
Views
1K
BCE75
BCE75
orlandoa11
  • Locked
  • Question
NX user interface customization - commands and border bars 1
Replies
3
Views
471
Bleaker
Bleaker

Part and Inventory Search

Sponsor

Back
Top Bottom