FeSE
Structural
- Sep 7, 2007
- 32
Hello all,
I am designing double channel bracing for a project. Has anyone seen or developed a spreadsheet for this?
No, I'm not looking for the way around learning the specification. I am a seasoned structural engineer trying to make a profit by using as much shareware as possible. I believe that we could learn a lot from programmers. By sharing sourcecode they have been able to achieve far more as a collective body. Software is like underware... ...required, but need not be expensive.
I am willing to write this spreadsheet. Does anyone at least have tabular data assembled for double channels? AISC 13th preffered.
No, Mr. Li has not done this yet.
I promise that I will never attempt to charge for my 'ware
I am designing double channel bracing for a project. Has anyone seen or developed a spreadsheet for this?
No, I'm not looking for the way around learning the specification. I am a seasoned structural engineer trying to make a profit by using as much shareware as possible. I believe that we could learn a lot from programmers. By sharing sourcecode they have been able to achieve far more as a collective body. Software is like underware... ...required, but need not be expensive.
I am willing to write this spreadsheet. Does anyone at least have tabular data assembled for double channels? AISC 13th preffered.
No, Mr. Li has not done this yet.
I promise that I will never attempt to charge for my 'ware