drawing breaks and views

[williedawg]

SW2006

can the vertical (or horizontal) break width be varied so as to include the resultant view within it, as per example?

 

[BluTurtle]

You may want to consider Breakout Section View


~ BT

 

[MadMango]

I know it wasn't possible, but now is. I think the capability came in in SW08 or SW09.

"Art without engineering is dreaming; Engineering without art is calculating."

Have you read faq731-376 to make the best use of these Forums?

 

[MadMango]

Sorry my reply was a bit cryptic, hit Enter too soon. You can add multiple Breaks in a single drawing view.

"Art without engineering is dreaming; Engineering without art is calculating."

Have you read faq731-376 to make the best use of these Forums?

 

[williedawg]

found the setting..

appears the callout is a +- dimension from the nominal "center" of the break, i.e. .75 would make the space between break lines 1.50

 

[MadMango]

I read your post too quickly, I don't think changing the size of the Break will give you the cross-section as in your example. You'll probably have to do as BluTurtle suggested.

"Art without engineering is dreaming; Engineering without art is calculating."

Have you read faq731-376 to make the best use of these Forums?