Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drawing links in assembly

Thread starter Amar005
Start date May 5, 2011

Status: Not open for further replies.

May 5, 2011

Amar005

Automotive

Hi All,

I have an BIW Assembly with door trim.I have created master section drawing in ug nx5.
But after completion of drawing I am unable to find out links of every view or sheet.

It is possible to find out links of the drawing and can we edit it?

Please giude if anyone has an idea regarding this?

Thanks in adavance.

Regards,
Amar