Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drawing Out of Date Mark on TIFF image

Thread starter EnJoeNeer
Start date Aug 30, 2007

Status: Not open for further replies.

Aug 30, 2007

EnJoeNeer

Mechanical

Does any body know of a way to read information from the drawing "information" window? I would like to use NX open to place a mark on a drawing to show that it is out of date. I know NX tells you, but that does not show up in a TIFF image. Any suggestions on where this tag might reside?