Drawing View Error - Invalid Zone Label Font 1

[jerry1423]

I am on NX1884.
I am getting an error that I do not understand.
I need to toggle ON "Process Secondary Geometry" in my drafting preferences.
When I do that and try to press OK I get the error "Invalid Zone Label Font".

I have a part that is made from sheet metal and I need to add a component that is welded to it.
Therefore I have a single file with the sheet metal model and flat pattern, along with an imported component.

I have no idea what the "zone label font" is.

What is going on here ? What do I need to do to get my drawing views to show properly ?

There was a time when this was very easy. Now I don't know what is going on. The only view I can work on is the flat pattern.

Jerry J.
UGV5-NX1884

 

[cowski]

The zone font setting can be found in the drafting preferences -> drawing format -> borders and zones -> zones.

www.nxjournaling.com

 

[jerry1423]

Thanks Cowski,

This turned out very strange, but it now works.
In my situation The Zone Label Font cannot be BlockFont, so I changed it to Arial.

Jerry J.
UGV5-NX1884