Drive shaft - Center Bearing Bracket

[shivkug]

Rubber bound CTR BRG BRKT,
I am always doing some small design modifications to this part. But never done any new project.

I started thinking about first step and initial inputs required to design this part in the drivline.

Can someone guide me with intial steps in designing this part. so that i can understand my work better

Regards,
Shivkumar

 

[Tmoose]

real low natural frequency, i.e. hollowed out soft rubber. I wonder if The outfits that make stiffer urethane mounts may get calls from time to time complaining about noise and vibration issues that the hard mounts cause.

 

[truck]

While low rate center bearing isolators do improve NVH a lot, the stiffer isolators are used with higher horsepower (e.g., high lateral reaction loads. The stiffer isolators also respond beter to thrust loads and diminish the affect of dust shield cutting.

Truck