Editing a WPQ (QW-484 Form)

[JamesPhelan]

Based on our (mis)understanding of Section IX when we completed WPQ's in the past we only listed the P No. for the actual test performed as our qualified range. It is now apparent that the P No. used for the test (P8) will qualify us for P1 to P15F per QW 423. I am fairly confident that my understanding of this is correct. I am unsure of how to edit the qualification range on a WPQ that has already been completed and signed by my Weld Trainer and 3rd party testing lab. Any thoughts?

 

[qcrobert]

Simply fill in the qualification range, initial & date the correction.

You are not changing anything, you simply left out information.

 

[Kiwi2671]

James,
It is P1 to P11, not P15,
Regards,
Kiwi

 

[Duwe6]

And show your Procedure revision level as going from -0- to -1-.

 

[JamesPhelan]

Kiwi2671,

My 2010 Edition of Section IX, QW-423.1 reads P1 to P15F. Not sure about yours...

Thanks for the info everybody...

 

[Kiwi2671]

My apologies James,
Looking at ASME IX 2007,
Regards,
Kiwi

 

[Onevan]

Hi James,
Your welder will also be covered for P34 & P41 through P49.
Best Regards,

 

[stanweld]

While the base materials for which the welder is qualified may be as stated, the welder may not be able to weld those materials with the welding filler, F-Number qualified.