Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

eDrawings Print Settings

Status
Not open for further replies.
macduff

macduff

Mechanical
Dec 7, 2003
1,255
All,
Is there a way to save your print settings in the eDrawings software? I'm trying to print out of PDMWorks using eDrawings at 11 X 17 as the defualt. But each I print it defaults back to 8.5 X 11. I also open the eDrawings software itself to try and save it there and had no luck.

Thanks,

Macduff [spin]
Meggitt Airdynamics Inc.
Dell Precision 370
SW2005 Pro SP 1.1
XP Pro SP2.0
NIVIDA Quadro FX 1300

 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

Paul D
  • Locked
  • Question
PDM print addin paper sizes
Replies
1
Views
165
SBaugh
SBaugh
VmaxVboost
  • Locked
  • Question
3D print plastic fuel cap, thread callout?
Replies
5
Views
205
drawoh
drawoh
Joeseph55
  • Locked
  • Question
Copy Wizard Settings
Replies
2
Views
146
Joeseph55
Joeseph55
bjlasota
  • Locked
  • Question
What are your go-to ways and settings for creating and/or modifying 2D prints in SW? 1
Replies
5
Views
212
Kenny_G
Kenny_G
Joeseph55
  • Locked
  • Question
Copy Settings Wizard
Replies
3
Views
131
SBaugh
SBaugh

Part and Inventory Search

Sponsor

Back
Top Bottom