zackngineer
Structural
- Jan 31, 2024
- 18
I was reading this thread: Link
Multiple engineers were using infinite edge distance when running their analysis. At what point/dimension does this become acceptable?
When I tried to recreate their calculations using my software, I was only able to get their designs to work if we treat the edge distance in the shear direction as infinite. If I put any dimensioned edge distance, the designs fail.
Multiple engineers were using infinite edge distance when running their analysis. At what point/dimension does this become acceptable?
When I tried to recreate their calculations using my software, I was only able to get their designs to work if we treat the edge distance in the shear direction as infinite. If I put any dimensioned edge distance, the designs fail.