wmalan
Aerospace
- Dec 12, 2003
- 297
Can't seem to see through the fog today - should be simple...
Using NX 6.0.4.
In the pic you'll see a planer mill op finishing a floor is 4 passes using Profile - Stepover - Multiple - .25" - .05" - 0.0." - 0.0". I'd like all passes to engage near the same location.
I've set Default Region Start point - Mid point. I even selected a mid point. Either way the first 3 passes start near the mid point but the last pass always starts at that location shown regardless of settings. Can't see a good reason to have the tool travel there.
--
Bill
Using NX 6.0.4.
In the pic you'll see a planer mill op finishing a floor is 4 passes using Profile - Stepover - Multiple - .25" - .05" - 0.0." - 0.0". I'd like all passes to engage near the same location.
I've set Default Region Start point - Mid point. I even selected a mid point. Either way the first 3 passes start near the mid point but the last pass always starts at that location shown regardless of settings. Can't see a good reason to have the tool travel there.
--
Bill
