McDermott1711
Mechanical
- Nov 17, 2010
- 318
Hi there,
Clause 7.6 of ISO 9001:2008, says:”… When used in the monitoring and measurement of specified requirements, the ability of computer software to satisfy the intended application shall be confirmed. This shall be undertaken prior to initial use and reconfirmed as necessary. NOTE Confirmation of the ability of computer software to satisfy the intended application would typically include its verification and configuration management to maintain its suitability for use.”
On the Other hand, in ASME V&V 10-2006, we have guidance for Verification and Validation in Computational Solid Mechanics.
Is there anybody out there that has an experience in preparation of a procedure for V&V of computer packages which are used in engineering design process, e.g. Caesar II, Ansys, etc.?
Clause 7.6 of ISO 9001:2008, says:”… When used in the monitoring and measurement of specified requirements, the ability of computer software to satisfy the intended application shall be confirmed. This shall be undertaken prior to initial use and reconfirmed as necessary. NOTE Confirmation of the ability of computer software to satisfy the intended application would typically include its verification and configuration management to maintain its suitability for use.”
On the Other hand, in ASME V&V 10-2006, we have guidance for Verification and Validation in Computational Solid Mechanics.
Is there anybody out there that has an experience in preparation of a procedure for V&V of computer packages which are used in engineering design process, e.g. Caesar II, Ansys, etc.?