Enhanced Scenes Updating 4

[TheMan51]

I've created 5 enhanced scenes for an assembly.
Geometry was modified on one part. Another part was
coincident to this modified part. Of course when I updated
the assembly the coincident parts mated together.
But the enhanced scenes did not show the update.
How would I update the enhanced scenes?
Thanks.

 

[mechanicalman1]

When you enter into a enhanced scene, you are given 2 options, partial and full. Sounds like you have selected full (this locks the scenes as soon as you have created them). Partial mode updates as the assembly does, I think.....

 

[luvhagen]

...and you can try to overload position from assembly to scene by rightclick on the scene in the application node in the tree, and select "Apply assembly on scene".
If you have created an Full Enhanced scene (shown in the tree by a red coordinatesystem instead of black when partial scene, sometimes you need to convert it with this steps:
1) Select the scene in the tree
2) Run Enhance scene-icon
3) Make sure it is partial selected in dialogbox.
You have now created a partial from the full, so you can delete the full scene.
Good luck

 

[TheMan51]

thanks to all for input.
I now understand more of enhanced scenes.

 

[thixoguy2]

A big thanks to mechanicalman1 and luvhagen, I too FINALLY understand enhanced scenes.

thixoguy